Jenn-Air JDB9000CWB Manual y guía del usuario descargar pdf (Pagina 20)

THE CLEAN LIGHT IS

FLASHING

Check the following:

■ Is the overfill protection float able to move up and down freely? Press down to release.

■ Be sure the water supply is turned on to the dishwasher. (This is very important following the

new installation of your dishwasher.)

■ Check for suds in the dishwasher. If foam or suds are detected by the dishwasher sensing

system, the dishwasher may not operate properly or may not fill with water.

Suds can come from:

■ Using the incorrect type of detergent, such as laundry detergent, hand soap, or dish

detergent for hand washing dishes.

■ Forgetting to replace the rinse aid dispenser cap after filling (or refilling) the rinse aid.

■ Using an excessive amount of dishwasher detergent.

INTERIOR TUB LIGHTS DO

NOT COME ON.

Tub lights are not user serviceable. Call for Service.

PROBLEM RECOMMENDED SOLUTION

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 69 70

Sin comentarios

Jenn-Air JDB9000CWB Manual y guía del usuario Pagina 20